• Rust Development
    • Using Cross to Cross-comp...
  • Compile a C program for the board using SDK
    • Create a BSP using phyLinux
      • Add a Given Recipe to BSP
        • Add LVGL Demo into BSP
          • AM64x: Boot-selection
            • Copy SD Card Image to an SD Card
              • Copy Software to the Board via SSH and SCP
                • Getting and Running the PHYTEC VM
                  • Install FTDI Driver on Windows
                    • Set Static IP Address in Ubuntu 20.04 LTS
                      • Setup a Second Network Interface in the Virtual Machine
                        • Setup qbee Device Management on phyBOARD-Polis
                          • Using phyLinux to build a yocto BSP with a build-container
                            • Using thingsboard.io to connect phyBOARD-Polis to the Cloud

                              AM64x: Boot-selection

                              Hint

                              This tutorial is for the AM64x development board only.

                              Goal

                              Learn how to select the correct boot switch settings in this tutorial.

                              Tutorial

                              All settings use the "S3" and "S4" boot switches. These switches are shown in the image below:

                              SD Boot Settings

                              These settings will boot the board from the SD Card. 

                              eMMC Boot Settings

                              These settings will boot your board from the eMMC (internal storage on the board).

                              UART Boot Settings

                              These settings will boot your board over a given UART connection.