Introduction

This application note provides a guide for how to connect the 10” EDT display to the PHYTEC phyBOARD-Polis using the PEB-AV-10 Display Adapter.

Requirements

The following system requirements are necessary to successfully complete this Application Note. Deviations from these requirements are possible but may require the use of workarounds.

Connecting the Display

The following steps show how to correctly connect your display to the phyBOARD-Polis.

1. Connect the touchscreen cable to the Display Adapter (A) and to the back of the display (1).

2. Connect the backlight cable to the Display Adapter (B) and to the back of the display (2).
3. Connect the LVDS cable to the Display Adapter (C) and to the back of the display (3).
   phyBOARD-Polis Touchscreen Display Hookup Scheme (Touchscreen Display (Back) to Display Adapter - PEB-AV-10)
   phyBOARD-Polis Touchscreen Display Hookup Scheme (Touchscreen Display (Back) to Display Adapter - PEB-AV-10)
4. Connect the Display adapter (PEB-AV-10) to the phyBOARD-Polis (X16 and X18).

        Connecting the phyBOARD-Polis A/V (X16 & X18) to the Display Adapter (PEB-AV-10)(bottom)

         Connecting the phyBOARD-Polis A/V (X16 & X18) to the Display Adapter (PEB-AV-10)(bottom).

Revision History

Please contact our technical support if you need additional information or have any questions.

Copyrighted products are not explicitly indicated in this manual. The absence of the trademark (™ or ®) and copyright (©) symbols does not imply that a product is not protected. Additionally, registered patents and trademarks are similarly not expressly indicated in this manual.

The information in this document has been carefully checked and is considered to be entirely reliable. However, PHYTEC Messtechnik GmbH assumes no responsibility for any inaccuracies. PHYTEC Messtechnik GmbH neither gives any guarantee nor accepts any liability whatsoever for consequential damages resulting from the use of this manual or its associated product. PHYTEC Messtechnik GmbH reserves the right to alter the information contained herein without prior notification and accepts no responsibility for any damages that might result.

Additionally, PHYTEC Messtechnik GmbH offers no guarantee nor accepts any liability for damages arising from the improper usage or improper installation of the hardware or software. PHYTEC Messtechnik GmbH further reserves the right to alter the layout and/or design of the hardware without prior notification and accepts no liability for doing so.

@ Copyright 2023 PHYTEC Messtechnik GmbH, D-55129 Mainz.

Rights - including those of translation, reprint, broadcast, photomechanical or similar reproduction and storage or processing in computer systems, in whole or in part - are reserved. No reproduction may occur without the express written consent from PHYTEC Messtechnik GmbH.